Water damage in Burbank houses and apartments
Most Burbank homes are one of two kinds of building. There are single-story houses from the war years, and there are units in the bigger apartment buildings downtown. Los Angeles Water Damage Cleanup answers at any hour and gets a licensed, insured crew out for water damage restoration in Burbank, CA, then stays on the job until every wet room reads dry.
The first questions on the call are about the building. Its age, floor and plumbing tell the crew where the water likely went and which walls get opened to dry it.

1940s houses in 91505 and 91506
Burbank filled in around the aircraft plants. Lockheed moved to the city in 1928 and had 16,659 people on the payroll by 1941, and the housing tracts followed. The city’s historic preservation plan maps whole areas of post-war single-family homes, built out mainly between 1945 and 1950, most of them versions of the California ranch house.
The Census Bureau’s American Community Survey (2020-2024) shows how much of that is still standing. In 91505, 34.5 percent of homes were built in the 1940s. In 91506 it’s 31 percent. Roughly two-thirds of the homes in each ZIP went up before 1960, and most are detached houses.
On the call, your crew lead will want to know about the floor, the pipes and any rooms added later.
- Slab or raised floor. On a slab, water spreads sideways under the flooring and climbs the drywall from the bottom. The slab leak page covers drying floors over concrete. Over a crawlspace, water drops through the subfloor and pools on the soil. The crawlspace gets read and dried along with the room above it.
- Pipe that may be original or may be a repair. Tell us if the house has been repiped, and roughly when. After 80 years, the line inside a wall could be either, and that tells the crew whether to look for one failure or several. Pinholes and split supply lines are explained on the burst pipe and supply line page.
- Rooms added later. If a family room or bedroom was built onto the back of the original house, point it out. Water can travel under the joint where the old floor meets the new one.

Downtown apartments in 91502
91502 is the downtown ZIP, home to City Hall on Olive Avenue, and its housing looks nothing like the west side of town. Nine in ten homes there are rented. About a third are in buildings of 50 units or more, and more than three-quarters were built between 1960 and 2009.
In a building like that, a failed toilet fill valve or a supply line under an upstairs sink can come through the ceiling below before anyone upstairs notices. When you call, give us your unit number, the unit above you and whether the building manager knows. If the ceiling is stained, bulging or dripping at a light fixture, our page on leaks through the ceiling goes through what gets checked first. Who covers which unit, the tenant, the owner or the HOA, is laid out in the apartment and condo section of the insurance guide.
Whose pipe it is: BWP, Public Works or the owner
Burbank runs its own water system. Burbank Water and Power runs the mains under the street and sends its own crews when one breaks. Early in 2026 a main broke on Clark Street at Whitnall Highway just after midnight, and BWP reported it repaired by noon. By BWP’s count, more than 30 miles of its pipelines are over 100 years old, and it replaces up to 1.1 miles a year.
A broken main is BWP’s repair. The water that reached your garage or living room still has to be extracted and dried, and that part is what the call is for.
Sewer is split the same way. Burbank Public Works maintains the city’s sewer mainline, and under Burbank Municipal Code 8-1-107 the lateral that runs from the house to that main belongs to the property owner. The city’s own guidance says most backups can be prevented by keeping that lateral clear. When a toilet or tub drain backs up into the house, the cleanup is a sewage backup job: Category 3 water, with wet carpet and pad usually coming out.
Burbank ZIPs we cover
- 91502, downtown Burbank
- 91505
- 91506
Don’t see your ZIP? Call anyway and we’ll check your address.
Next door, the Glendale page covers the city to the east, and the North Hollywood page covers the apartment blocks and wartime houses to the west.

Drying a Burbank house until it reads dry
The dry-out on a Burbank job starts with a moisture meter, not with the fans. Your crew lead reads the floor, the bottom of the walls and the baseboards outward from the leak until the numbers come back normal, and that line becomes the moisture map. Extraction comes next, then air movers and dehumidifiers sized to the wet area.
On a raised floor, readings go into the subfloor and the framing underneath. On a slab, they follow the baseboards and the joints between flooring boards or tiles. Each visit gets logged, and the equipment comes out when the readings show the materials are back to dry, not when a set number of days is up. The full process, including how water categories and drying classes are set, is on the page about how water damage restoration works.
That log is the proof the job is finished. It also goes into your claim file next to your photos.
Burbank questions: utility lines and old houses
Is Burbank on LADWP?
No. Burbank has its own utility, Burbank Water and Power, for water and electricity. That only changes who repairs a broken main in the street. Extraction and drying inside the house work the same way on either side of the city line.
Can drying start before the insurance adjuster sees the damage?
Yes, once you've taken photos and a short video of every wet room and the source. Waiting for the adjuster lets water keep wicking up drywall and into the subfloor. The crew's moisture readings and daily log document what the photos can't.
How long will the equipment be in my house?
Until the readings say the materials are dry, which depends on how much got wet and what it's made of. After the first day's readings, your crew lead can give you a realistic estimate for your rooms.
Is someone available at night or on a weekend?
Yes. Someone answers 24 hours a day, 7 days a week. If water is still running, we'll start with where the shutoff is before anything else.

